61
General Mach Discussion / upgrading
« on: September 04, 2006, 10:46:28 AM »
If I upgrade from 1.8x to 1.9x I assume that I willnot lose any of my tuning? Thought I would ask before I actually did it.
Also on the FTP site I found the post processor for bobcad called "mach1 for v18" I again am assuming that is the lastest post processor?
Thanks.
Dan.
Also on the FTP site I found the post processor for bobcad called "mach1 for v18" I again am assuming that is the lastest post processor?
Thanks.
Dan.