Well not sure that this goes in show "n" tell but I think it is close...
Thought i would post how I am starting to manage a pen project in Microsoft OneNote which is a notes management software tool.
Here is the main page notice the tabs across the top:
From the main page I created an index of all the components I wanted to document. So far I have only done the compass.
Next you can go to the compass main page folder now notice the tabs on the right side. These are the steps in the process. I will show each one:
Now into the first tab marked set-up:
Next is the raw material. I can put a link to the website and I saved the page as a PDF encase the page ever changes.
Next is the DXF drawing file. I posted a photo and attached the actual file into the page:
G-code is the same style with a picture and the file:
Next is the tool I used to make the cut again I pasted the website and this time I did a screen capture of the tool.
Next I described how I sharpened the tool. This page is long with many pictures and a step by step method.
Next is the machine set-up again this is fairly long but I only captured a page to show it here:
This is the bending process:
And finally the enameling process:
Just thought I would share the idea.
Dan.