41
General Mach Discussion / Re: Configuring mach
« on: July 11, 2006, 06:27:43 PM »
Hi Brian,
Attached are the 2 files that i have managed to get out of them. They use mach 2 but it made more sense to me to use mach 3 - however i have 2 & 3 on the machine but cant make out what pin numbers to enter in the input etc boxes. I'm a toolmaker and not into electronics so finding it a bit hard going. The unit was meant to be plug and play!! When I have asked for an intsallation manual they tell me "they haven't finished writing it yet!!"
Thanks for the interest. The UK seems miles behind the USA - as usual.
Regards Jacko
Attached are the 2 files that i have managed to get out of them. They use mach 2 but it made more sense to me to use mach 3 - however i have 2 & 3 on the machine but cant make out what pin numbers to enter in the input etc boxes. I'm a toolmaker and not into electronics so finding it a bit hard going. The unit was meant to be plug and play!! When I have asked for an intsallation manual they tell me "they haven't finished writing it yet!!"
Thanks for the interest. The UK seems miles behind the USA - as usual.
Regards Jacko