11
Promote and discuss your product / New Photograph Carving and Engraving Software
« on: January 28, 2006, 12:37:19 PM »
Hi everyone,
Vectric have just launched - PhotoVCarve - a totally new software product for carving or engraving permanent photographs or images.
This is NOT the typical grayscale to height map method that typically takes hours to cut using ball nosed cutters, and often produces low quality results because the photo has the wrong lighting and shading required.
PhotoVCarve machines grooves across the photograph to reproduce the photograph in the base material. This means a design can usually be carved in minutes and the reults are very good.
It's really to use, instantly calculates the toolpaths and previews the results so yo ucan see what the job will look like when nachined.
Trial version that will cut your own pictures is available from the web site.
Hope this might be of interest to the community,
Regards,
Tony McKenzie
( tonym@vectric.com )
Vectric have just launched - PhotoVCarve - a totally new software product for carving or engraving permanent photographs or images.
This is NOT the typical grayscale to height map method that typically takes hours to cut using ball nosed cutters, and often produces low quality results because the photo has the wrong lighting and shading required.
PhotoVCarve machines grooves across the photograph to reproduce the photograph in the base material. This means a design can usually be carved in minutes and the reults are very good.
It's really to use, instantly calculates the toolpaths and previews the results so yo ucan see what the job will look like when nachined.
Trial version that will cut your own pictures is available from the web site.
Hope this might be of interest to the community,
Regards,
Tony McKenzie
( tonym@vectric.com )