Hello Guest it is March 28, 2024, 09:16:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 56speedster

Pages: 1
1
Newfangled Solutions Mach3 Wizards / Re: Multiple slot cutting wizard
« on: February 05, 2008, 10:15:41 PM »
Ron I appreciate what you are saying but I think a wizard capable of making multiple parallel cuts. slots or grooves could be used by many people for several projects such as cooling fins, drain pans, cosmetic grooved designs for motorcycle and automobile parts, tread plates etc.  I understand you cannot make wizards without a lot of work and effort and would not be feasible if not used by many people.  Thanks again, I will try the single slot wizard.

2
Newfangled Solutions Mach3 Wizards / Re: Multiple slot cutting wizard
« on: February 05, 2008, 04:20:25 PM »
Ron , I will try to describe a little bit better, the part is comb shaped with teeth approx. !/4" wide by 2" long and with slots approx. 1/4" wide and 2" long, material will be    3/4" thick. There will be 10 or so slots in each part. Hope this helps, thanks for your help, James

3
Thanks VMAX549, I guess this is the one place I missed :)

4
Newfangled Solutions Mach3 Wizards / Multiple slot cutting wizard
« on: February 03, 2008, 11:51:02 PM »
What is the best way to make multiple slot cuts using the wizard? Thanks for your help!!

5
Can someone tell me how to save the G-Code after loading from Newfangled wizard into Mach? Thanks for any help!!

Pages: 1