Messages

1

Newfangled Solutions Mach3 Wizards / newfangled lic needed.

« on: October 29, 2008, 11:18:07 AM »

hi,
i have a lic. version of Mach 3 that came with the cnc table i purchased new. The new fangled wizards are there, but i don't have a lic for them. How can i get one??

Mike

2

General Mach Discussion / Re: motor stalling during rapids

« on: January 26, 2008, 08:52:12 PM »

Thanks for the sugestions. i slowed down my motor acceleration and velocity and have been cutting today without problems. Hope that was all it was...easy fix.
thanks again........Happy cutting
Mike

3

General Mach Discussion / motor stalling during rapids

« on: January 26, 2008, 11:23:24 AM »

hi all, newbie here.
I'm having an issue with my Y axis motor stalling during rapid moves. It only hapens at times, (erratic). During a rapid, the "y motor will stop moving and make a loud buzzing noise, kinda like its trying to go 2 directions at once. The DRO continues to show movement until it shows it is at the destination. then the Z will go down to start the cut, BUT, in the wrong place. Has happened with many different G code files.
Any ideas??

Mike