Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jhewitt123

Pages: 1
1
General Mach Discussion / ncpod plug
« on: February 17, 2008, 01:25:12 PM »
Hi, I got no response as yet from other groups so I wanted to ask again here. My ncpod wroks fine under ncpod software. I have installed the plug-ins for Mach3, and get an ncpod box to check on startup of mach3. Why do I not get a USB box to check under the ports and pins config but still get just the maxnc box. How to I then get Mach3 to do anything with my pod?

John Hewitt
jhewitt123@comcast.net

2
Mach SDK plugin questions and answers. / ncpod plug-in
« on: February 15, 2008, 11:55:10 PM »
Does the ncpod plug-in for Mach3 change the ports and pins options to show the USB box instead of the maxnc?  I can not seem to get the usb box even though I have installed the plug in many many times in vain.

John H.

3
NC Pod / Re: what version of Mach3 do I need
« on: February 15, 2008, 11:14:10 PM »
Hi, I'd like to know this also. I just got my ncpod and it spins my motor with the OEM basic control panel, however, although I loaded the plug-ins and check the ncpod box when starting mach3, the mach3 "ports and pins" config area does not give me a usb selection to check like the one shown in the online picture, instead I get a "maxnc" box.

How do I use this ncpod with mach3 then?

Thanks for any help,

John H.


4
General Mach Discussion / Artsoft hardware
« on: January 25, 2008, 11:33:16 AM »
Hi, I just downloaded Mach3 and I looks great. I also sent money to the ncpod group for their hardware but cannot get a response from them. Are they a real company? I fear that since I can not even get a response from them now not only will there be zero support for their product but I may be out $115.00 as well.
Can someone restore my confidence?

John

Pages: 1