1
General Mach Discussion / Re: Calling all post processors. ( Help me to help you )
« on: January 14, 2008, 03:32:03 PM »I am trying to build a collection of all post processors for many CAM programs.
I was hoping if you had any I could use, you could upload them to this thread.
I will then host then in the new section here http://www.machsupport.com/cam.htm
Thanks for your help.
Benny
I have seup Sprut Cam 4.0 with Mach 3. I'm not an expert, so you may want to verify all the paramaters first, but It is working for me with my 3 axis mill and mach 3/Quantum.