Hello Guest it is May 10, 2021, 01:50:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - zander

Pages: 1
General Mach Discussion / Re: C rotation
« on: January 03, 2008, 03:59:22 PM »
Ok! So if I correct G Code and insted A360 F100 ... insert C360 F100  in *.tap file I can see no rotation of C axle on the table display.

General Mach Discussion / C rotation
« on: January 02, 2008, 03:31:19 PM »
Hello! I would like to cut off circle using C axle rotation table. What shall I configurate Mach3 correct? Could I see process in table display as A axle I could...

Pages: 1