Hello Guest it is March 29, 2024, 07:33:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Steve Nuttall

Pages: 1
1
swap 2 of the wires from 1 phase on the stepper motor
it will reverse

2
thanks

Thought i'd lost my mind

3
where did it go?
Or was i dreaming

4
Show"N"Tell ( Your Machines) / My Mills
« on: June 09, 2006, 07:49:34 PM »
There are lots of names i see here i know from CNCZone; but there are some i don't know
So i thought well post a pic and a link for those who might not have seen my builds


My Gantry mill
33" by 14" by 12" travels; VFD spindle (3/4HP) the taper is ER25 but I have made fixed length tooling too; The entire package is self contained; the computer (Sempron 3000+) and drives (3 x Zeta4) are contained in the box behind the Gantry bridge

During construction shot
Monitor and keyboard/mouse swing for veiwing and control is of course Mach3; there is a build thread on CNCZone about this machine; and there will be a webpage too; once i find time to make it

Here is the Mini Mill web page showing how i built this machine
webpage

Pages: 1