Hello Guest it is January 20, 2020, 03:36:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - C. J. Hung.

Pages: 1
1
General Mach Discussion / Re: about REF ALL HOME
« on: August 16, 2008, 10:46:30 AM »
I reduce debounce to 50 , and all function is ok !

Thanks again!

2
General Mach Discussion / Re: about REF ALL HOME
« on: August 15, 2008, 11:12:14 AM »
ok! I will try it tomorrow!
Thank you very much!

3
General Mach Discussion / Re: about REF ALL HOME
« on: August 15, 2008, 01:16:52 AM »
I set the debounce to 2000 today , and the "REF ALL HOME" function is ok !

Thanks!

4
General Mach Discussion / Re: about REF ALL HOME
« on: August 14, 2008, 12:28:52 PM »
Thank you very much! I will try it tomorrow .

5
General Mach Discussion / Re: about REF ALL HOME
« on: August 14, 2008, 12:06:31 PM »
thanks again , but I don't know what is " debounce " , could you show me where to setting( picture) please ?

6
General Mach Discussion / Re: about REF ALL HOME
« on: August 14, 2008, 11:56:55 AM »
Thanks for your reply , yes , I check so many times , the V2.63 setting is same to V2.065 .

7
General Mach Discussion / about REF ALL HOME
« on: August 14, 2008, 11:22:53 AM »
Hi !

I use the Mach3 v2.065 about two more years and everything was good , but I want to use MPG so I upgrade to v2.63 , and got a big
problem about REF ALL HOME , when I hit "REF ALL HOME " , first is Z axis move to home , but when Z touch limit switch , everything
is stop , than " RESET " is blink , I try so many version is same , only v2.065 can work right , is me setting wrong ?

sorry about my English!

Thanks!

Hung.

Pages: 1