Hello Guest it is April 09, 2020, 05:38:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JOE65

Pages: 1
1
General Mach Discussion / Re: SURFACE WIZARD
« on: June 06, 2006, 06:12:58 PM »
Thanks for all the info guys. I have finally got it  ;D

As an aside : Let me ask about the type of cutter shown in the wizard. I have a cheap (Asian) one that came with my Asian mill.
It has three inserts and I notice that they are not all at the same depth. Is this normal (each insert taking a progressively deeper bite) or are they supposed to be all at the same depth?

2
General Mach Discussion / Re: SURFACE WIZARD
« on: June 04, 2006, 07:44:07 PM »
Thanks for all your responses guys. Still not getting the results I,m looking for.
See screen shot.

3
General Mach Discussion / SURFACE WIZARD
« on: June 03, 2006, 01:35:42 PM »
I'm trying to use the Surface with tool down in x Wizard and not having much luck.

I'd like to rough cut to a certain z height and then slow feed rate down for finish cut last .002.

Is there info somewere on this wizard?



Pages: 1