Messages

1

General Mach Discussion / Re: CHNC retrofit

« on: February 09, 2008, 08:49:34 PM »

I saw a notice of a convention for Mach in Knoxville, TN., and now I don't see anything about it. It was supposed to be February 23,24th, I think
Larry

2

General Mach Discussion / Re: CHNC retrofit

« on: February 09, 2008, 04:21:15 PM »

I have a couple of questions.
1. Where did the Artsoft Convention go?
2. Has anyone actually retrofitted a Hardinge CHNC? If so, does someone have the bill of material, etc.
Thanks

3

Show"N"Tell ( Your Machines) / Re: Help! Hardinge CHNC Retrofit

« on: February 08, 2008, 07:59:09 AM »

I have a Hardinge CHNC that I would like to replace the GE Mark 550 with the Mach3. Has anyone actually done this and if so, did you keep your documentation?
Any help would be appreciated.

4

Show"N"Tell ( Your Machines) / Re: hardinge hnc to retrofit

« on: November 25, 2007, 10:52:26 AM »

Drew, I have a Hardinge CHNC that has a GE Control and I would like to retrofit with a Mach 3. Have you indeed retrofitted one of these?
Larry

5

General Mach Discussion / Re: CHNC retrofit

« on: November 25, 2007, 08:47:36 AM »

I have a Hardinge with a GE control that I would like to retrofit. Have you figured it out?
Any help would be appreciated.