1
General Mach Discussion / Re: Deskengrave cutting double lines
« on: November 24, 2007, 05:23:09 PM »
Hi Whacko, thanks for that info. I did some experimenting and found that a file created on my old computer (win98) then loaded into Mach3 worked OK so the fault is obviously with XP as you suggest. For the moment I am happy to create the files I want on my laptop (also Win98) and transfer them over. Incidentally, all the other fonts work OK under XP - go figure. To answer your question, Deskengrave exports in DXF or gcode.
Thanks again for your help, Trevor
Thanks again for your help, Trevor