Hello Guest it is March 28, 2024, 09:51:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Hllrsr

Pages: 1
1
Aternoon Folks,

New guy to the forum, and Mach3, but I've been doing the cnc building thing for a while.
Currently have 4 working routers running TCNC, Emc2 (closed loop), and I've just set one up with the trial version of Mach for digitizing.
What got me looking closer at Mach was a posting on the CNC Zone about Art's laser scanning adventures, and if they pan out I'll have to bite the bullet and actually pay for a control software.

I'm a firm believer in supporting a company/individual who develops affordable gizmo's to feed my hobbies.. ;)

Been working industrial maintenance since leaving college in 91, and currently have a lot of time on my hands with having to go on disability. So to keep from going insane from boredom I'm trying to learn VBA to customize Mach.

Check back in ohh..2-3 years and I may understand what the VBA for Dummies book is trying to tell me. :P

Iain

2
Video P*r*o*b*i*n*g / Re: Photos of webcam scanner. ( no laughing.. :) )
« on: November 11, 2007, 08:57:21 PM »
Looking forward to it, and since the touchless scanning is one of my biggest wishes for a CNC ( the David software doesn't count, too difficult to set up) looks like it's time to buy a full version of your wonderful little program!

ATB

3
Video P*r*o*b*i*n*g / Re: Photos of webcam scanner. ( no laughing.. :) )
« on: November 11, 2007, 08:00:25 PM »
Art,
Any probable ETA on this oh so sweet addon?
I'm currently using Emc2 as (closed loop) control software, with a trial version of Mach on a second machine for the digitizing, but for this little gem I'd even be willing to dump the Emc!

Iain

Pages: 1