Messages

1

General Mach Discussion / Re: Crazy zero

« on: July 06, 2019, 09:24:33 AM »

Thank You I will give it a try.


 Bruce

2

General Mach Discussion / Re: Crazy zero

« on: July 06, 2019, 02:54:06 AM »

  Attached is the code   

 Thanks

3

General Mach Discussion / Crazy zero

« on: July 06, 2019, 12:10:03 AM »

I have been trying for some time to get my Grizzly G0 704 mill to work correctly. Here is what happens. I did a design in Fusion 360 and did the code. When i try to start the program the tool is set to zero on the surface of the stock. When I press start the Z axis goes up usually till it hits the end of travel and keeps going loosing its place. is it with my code or is it my machine setup? I have a router that works great and this has me stumped. 

 Bruce

4

General Mach Discussion / Re: backing off home switch

« on: April 26, 2016, 07:47:08 PM »

  Thanks for the answers I had the switches wired wrong. I fixed it.

 Thanks all
 Bruce

5

General Mach Discussion / Re: backing off home switch

« on: April 26, 2016, 03:49:36 PM »

  I figured it out    thanks       that's what is was my switches were wrong.

6

General Mach Discussion / backing off home switch

« on: April 26, 2016, 01:48:49 PM »

 Hello when my machine is set to ref all home the z-axis goes to trip the switch but it will not back off. The reset button lights and I have to turn the power off move it off the switch by hand then power it back up and hit the reset button. Then the machine will move again



    Thanks Bruce

7

General Mach Discussion / Re: problems with ports

« on: April 30, 2009, 09:12:13 PM »

I ordered a new computer system with only windows xp on it . Maybe this will eleminate some of my problems. It should be built by the time I get off work next week.

 Bruce

8

General Mach Discussion / Re: problems with ports

« on: April 28, 2009, 11:11:48 PM »

 Sorry I haven,t had time to test out my ports. Work you know! have to leave tomorrow for a week at work won't get back until Wednesday of next week. No time to play! the system works with KCAM so I will probably just use that so I can get down to learning to make parts instead of trouble shooting Mach3. 

 Thanks Bruce

9

General Mach Discussion / Re: problems with ports

« on: April 27, 2009, 10:00:55 PM »

  I increased the pulse width to 5 already. I do use a breakout board.

  Bruce

10

General Mach Discussion / Re: problems with ports

« on: April 27, 2009, 01:00:26 PM »

  My jog settings are continuous and the motor only moves one way and only one step. The DRO's move as they should.

 Bruce