Hello Guest it is March 29, 2024, 06:50:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Netjams

Pages: 1 2 »
1
Forum suggestions and report forum problems. / Test forum?
« on: May 15, 2007, 06:18:28 PM »
Do you have a test forum?

A place to test signitures and stuff like that.


2
Hmmm..  VERY NICE!!   ;D

3
General Mach Discussion / Re: Why is everything mirrow imaged?
« on: May 17, 2006, 10:07:12 AM »
Everything works fine now.

Thank you so much!  ;D

4
General Mach Discussion / Re: Why is everything mirrow imaged?
« on: May 16, 2006, 02:00:57 PM »
Thanks I will fix that after work.  ;D

5
General Mach Discussion / Re: Why is everything mirrow imaged?
« on: May 16, 2006, 10:22:44 AM »
Bad spelling on my part...  :-\

Checking with spell check....

Mirror  ;D

Ok let's say I use the text wizard in Mach3 with the mirror option selected (blinking).
What I see in the work area is the text I entered but the machine cuts it like im looking in a mirror at it.
I have to select the mirror option (that will make it display in the work area backwords) to get it to cut correct..

I think I just figured it out. It is the use of the text wizard that I'm not setting correct.


6
General Mach Discussion / Re: Why is everything mirrow imaged?
« on: May 16, 2006, 07:39:40 AM »
If I use the Text wizard, I have to select the mirrow and let it display on the screen in mirrow in order to get it to cut correct.

I will look around for a setting in config to change it.

7
General Mach Discussion / Why is everything mirrow imaged?
« on: May 15, 2006, 08:01:53 PM »
I didn't see it till I started to work with text.
I understand at this point the Gcode is the commands that make this happen, but it also happens with the wizards in Mach3.

Am I alone on this problem? ::)

8
General Mach Discussion / Re: Mach2 works fine but...
« on: May 12, 2006, 11:30:54 PM »
Ha.. That worked  ;D

But it may also be that the offline button flashing green (me thinking it's online) could be the problem  :-\

You need to make the text on that button say "On Line" and flash green when it's online and "Off Line" flashing red when off line.

Anyway... Thanks for the help and here is to many broken bits in the furtue  ;D

9
General Mach Discussion / Re: Mach2 works fine but...
« on: May 12, 2006, 10:46:05 PM »
Ok...

Wiil do a reinstall  ;D

Sorry about the loss of the server for a few moments, I was changing bios setting on the port to see if that may be the bug, but watching the activity after the changes it looks like Mach2 and 3 use the same engine  ;D

See I'm learning fast ;D

Thanks!

I will post the results  :-*

Pages: 1 2 »