Show Posts

1

Sieg Machines / sx3 spindle sensor

« on: January 30, 2011, 01:16:55 PM »

i have a sx3 running mach3 i was wondering is there any way to use the speed sensor to feed mach3 the speed info through a g540? . i have recently used it as a lathe but would like to rig up the spindle feedback for screw cutting

regards mick

2

General Mach Discussion / Re: using x3 mill as a lathe

« on: January 25, 2011, 03:57:09 AM »

thank you very much for the prompt reply.
would i be able to save these positions & would this be an offset save?

mick

3

General Mach Discussion / using x3 mill as a lathe

« on: January 25, 2011, 03:29:39 AM »

i am able to run my mill under the control of mach lathe but i dont understand how i can move they y axis. if i had 3 seperate tools clamped on the table how would i zerz each of these. any help would be great
regards mick

4

Mach Screens / using my mill as a lathe

« on: January 25, 2011, 03:27:54 AM »

i am able to run my mill under the control of mach lathe but i dont understand how i can move they y axis. if i had 3 seperate tools clamped on the table how would i zerz each of these. any help would be great
regards mick

5

Newfangled Solutions Mach3 Wizards / thread milling

« on: October 05, 2010, 04:21:34 AM »

when using the thread milling wizard.it only produces half the code could you please help

6

Forum suggestions and report forum problems. / MDI

« on: May 02, 2008, 08:00:15 AM »

hi i am using the latest download on my taig mill i have been cutting some very nice crossed helical gears but once the program has finnished i close the g code but cant get any responce from the MDI input can anyone help

7