Hello Guest it is August 06, 2020, 09:43:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ClemsonGirl

Pages: 1
1
General Mach Discussion / New to everything, and a big question
« on: May 03, 2006, 03:13:26 PM »
Hello everyone,

I wanted to introduce myself on here.  I am a current university student and have been running a small business for the past couple years.  Last week I purchased a new TAIG cnc machine with the Xylotex board (4 axis).  I make and sell pewter pendants.

I am using solidworks 2004 to design, exporting to MeshCAM, then to Mach3.  So far, I am great at solidworks...but after that I'm lost.

I was wondering if anyone had any suggestions about my setup in Mach3.  Does anyone have their machine set for a Taig with the Xylotex board, and I could just copy your settings file?

Since I am so new to this, is there anything I can do to break the machine while playing with it?  Anyway, I hope to participate a lot on here as I begin to learn this exciting new hobby. 

Thanks in advance,

-CG

Pages: 1