Hello Guest it is November 15, 2019, 03:25:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - cosmynnec

Pages: 1
General Mach Discussion / Dwell question
« on: July 17, 2006, 12:30:15 PM »
Hello, how can i trigger an output when the dwell command is active ? Thanks

How can i do an Mcode ?

LazyCam (Beta) / Re: Help with LazyCam
« on: May 04, 2006, 07:51:47 AM »
Yes my problem is the cutter dia. if i don't check that option "Use G41/G42 .... " when i want to generate the g-code it's working but without compensation. I think that the program reverses the G41 and G42 codes.

LazyCam (Beta) / Help with LazyCam
« on: May 03, 2006, 12:56:56 PM »
I have this part with 2 layers, the 1 layer the outside of the piece the 2nd layer the circle in the middle of the piece.

I have tried everyway I can to get LazyCam to cut the circle on the inside instead of the outside. But it continues to cut outside . If I enable a straight lead-in of 3mm the leadin extends beyond the edge of the circle

Pages: 1