Messages

1

Mach4 General Discussion / No movement in x-direction when jogging

« on: August 05, 2022, 10:22:42 AM »

I have a cnc machine that will move in the x-direction when I use the motor testing option under configure>plugins>hicon>motor, but when I try to jog it, it still does not move in the x-direction. Anyone else have this issue?

2

General Mach Discussion / Motion Control issues

« on: August 03, 2022, 11:45:40 AM »

I have an old CNC machine that I am using for WAAM purposes. I have the motion in the y-direction working, but the x and z are not. Additionally, the y motion is moving in the opposite direction than it is supposed to. Any suggestions?

3

HiCON Motion Controller / No CPU light on HiCON Integra 7766

« on: July 05, 2022, 10:15:42 AM »

I am working on an old CNC machine that is wired to the HiCON Integra 7766. I have downloaded Mach4 and began the integration process. At one point, the HiCON Integra was being detected by Mach4. However, I rewired my inputs and must've unplugged something relating to the CPU power, as Mach4 can no longer detect the HiCON.
I have unplugged and doublechecked that both 24V and 5V inputs have power (used voltmeter) and reconnected wires, and CPU light still does not light up.
Any suggestions?