1
FAQs / Re: find no hxcusb pod error
« on: July 11, 2022, 06:56:42 AM »
Thanks for your interest.
I went to Mach3 downloads and found hxcusb download and that seems to have fixed the no hxcusb pod error but now I can't seem to get motors to turn not sure if its pins are wrong or something else.
not sure how to get the correct pinouts or if that is the problem.
I backed up and rewired my rich auto a ll DSP back up.
I have an older driver board and steppers that I got from buildyourcnc.com
and followed the wiring instructions to get one motor turning but I don't know how to figure out what step signals to use.
I am not getting any response to the motor so far.
Thinking about opening up the enclosure to see if there are any indications of pinouts.
Any help would be appreciated if anybody has any knowledge of these controllers.
controller card wixhc mk4-v
Stepper Motor Driver CW8060
Thanks
I went to Mach3 downloads and found hxcusb download and that seems to have fixed the no hxcusb pod error but now I can't seem to get motors to turn not sure if its pins are wrong or something else.
not sure how to get the correct pinouts or if that is the problem.
I backed up and rewired my rich auto a ll DSP back up.
I have an older driver board and steppers that I got from buildyourcnc.com
and followed the wiring instructions to get one motor turning but I don't know how to figure out what step signals to use.
I am not getting any response to the motor so far.
Thinking about opening up the enclosure to see if there are any indications of pinouts.
Any help would be appreciated if anybody has any knowledge of these controllers.
controller card wixhc mk4-v
Stepper Motor Driver CW8060
Thanks