1
Mach4 General Discussion / Re: Mach 4 DRO Reading Incorrectly
« on: May 02, 2022, 12:33:21 PM »
I am in incremental Jog mode. I have experimented with the jog rate% to no avail. I also contacted mach support and received a message basically stating "you cant just set the motor to move 1 unit and expect it to move 1 unit. That's not how its supposed to work." They also suggested "looking into tuning your motors" This is neither an answer, or even a relevant response, to my inquiry. Even if the motors were grossly out of tune (which they are not) I don't understand how that is relevant to Mach4 not moving 1 unit, which I have defined via the steps per unit calibration, on the DRO once commanded to do so. Instead it shows a movement of 50 units...