1
SmoothStepper USB / Re: Probe not retracting
« on: January 11, 2022, 11:23:58 AM »
Thanks Craig. I am probably not using the correct terminology here but this is what is happening. The probe is wired to the Probe Touch Sensor with is only activated when probing. When the probe touches during probing it acts like a relay trips, the touch sensor is deactivated and signal s send to the controller that it has touched. So there is no noise since it simply trips the sensor. I did try putting in 5000 for a noise filter but nothing changed in the operation.
It really acts like Mach4 is wanting a constant probe sensor signal once it touches but that is not possible with the Touch Sensor that I have. I cannot find a setting that allows to change that. Could this be the problem?
It really acts like Mach4 is wanting a constant probe sensor signal once it touches but that is not possible with the Touch Sensor that I have. I cannot find a setting that allows to change that. Could this be the problem?