1
Newfangled Mill Wizard / Re: MillWizard Rectangle Pocket Gcode Explanation?
« on: December 04, 2021, 05:14:56 PM »
They still sell it so I would think they would know if there was a problem.
I have the same exact issue... says I am downloading 2.0.5 but it is really .4 when installed. Could be as simple as fixing their download server.
He pretty much had no idea what I was talking about and sent me the manual.
I was able to get rectangular pocket to work but I couldn't duplicate how I did it. I was going to go back into the job and try and reuse it to create another job and see if bug stays out.
To use rectangular pocket now, I just edit the g code in notepad and delete the negative sign and program works fine... only for 0 degrees I think. Gets more complicated if it misses in positive because then you have to change entire value.
I have the same exact issue... says I am downloading 2.0.5 but it is really .4 when installed. Could be as simple as fixing their download server.
He pretty much had no idea what I was talking about and sent me the manual.
I was able to get rectangular pocket to work but I couldn't duplicate how I did it. I was going to go back into the job and try and reuse it to create another job and see if bug stays out.
To use rectangular pocket now, I just edit the g code in notepad and delete the negative sign and program works fine... only for 0 degrees I think. Gets more complicated if it misses in positive because then you have to change entire value.