Messages

1

General Mach Discussion / Re: THC301 screen set and post processor file???

« on: November 17, 2021, 02:01:35 PM »

I'm also looking for an installation manual or input and output pin numbers.
I would appreciate any help.

2

General Mach Discussion / Mach3 THC301d pin numbers

« on: October 14, 2021, 06:43:59 PM »

I running Mach3 with a Texas Microcircuit THC301d with a parallel cable to com port 2. Everything was working fine till my break out broad for the servos went dead. Got a new break out broad installed and got it up and running but my THC doesn't work. I think I changed a few pin numbers. I should have recorded everything. Does any one have an installation manual or the the pin numbers for the inputs and outputs used by the THC301d.
Inputs port 2
E-Stop
THC on
THC up
THC down
Outputs port 2
I do not know what's needed for outputs.

3

Mach4 General Discussion / Re: THC301d pin numbers

« on: October 14, 2021, 06:32:07 PM »

Thanks,
Jim

4

Mach4 General Discussion / THC301d pin numbers

« on: October 13, 2021, 06:56:48 PM »

I running Mach3 with a Texas Microcircuit THC301d with a parallel cable to com port 2. Everything was working fine till my break out broad for the servos went dead. Got a new break out broad installed and got it up and running but my THC doesn't work. I think I changed a few pin numbers. I should have recorded everything. Does any one have an installation manual or the the pin numbers for the inputs and outputs used by the THC301d.