Guest
Show Posts
1
General Mach Discussion / Older Mitsubishi drive question
« on: September 27, 2021, 02:06:07 PM »
Hi all! I am new to this board and hoping I can get a little help. I'm sure this has been brought up before, but my issue is this.
I have a shop saber 48x96 that was purchased in 2006. recently I ran my Y axis servo a little to hard and had to replace it.
My drive is an older MR-E-40A-QZ. When hooking up the new servo, I get an overload error right away.
I downloaded the MR 2 Configurator so I can have a look, but the drive is not on the list.
So, my question is, is there an older MR 2 config to download? or is there another software out there that is compatible with that drive?
Hoping someone out there had a similar issue.
Thanks, Brian
I have a shop saber 48x96 that was purchased in 2006. recently I ran my Y axis servo a little to hard and had to replace it.
My drive is an older MR-E-40A-QZ. When hooking up the new servo, I get an overload error right away.
I downloaded the MR 2 Configurator so I can have a look, but the drive is not on the list.
So, my question is, is there an older MR 2 config to download? or is there another software out there that is compatible with that drive?
Hoping someone out there had a similar issue.
Thanks, Brian