Hello Guest it is March 28, 2024, 11:32:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - spawacz_rider

Pages: 1
1
I did have similar issue the other day, when I was probing tool it went true pass the signal from the probe (good I have E-Stop on the probe as well)
That did happen when i was using MDI
The problem was the G code

G91 G31 G1 Z-30 F150 -when I did in this order It did crash
G91 G1 G31 Z-30 F150 - works without issue

Hope that will help

2
PoKeys / Re: Pokeys57CNC/Mach4 and 2 Probes
« on: August 22, 2021, 05:44:23 PM »
I would pass the probe signals through a relay that is switched by an M code into G31

I was thinking about that but my Auto Z hight is NC and touch probe for Y and X will be NO.
So this whould not work, at leaset whithout coding in the background (I'm not good at that)

Thanks anyway

3
PoKeys / Re: Pokeys57CNC/Mach4 and 2 Probes
« on: August 19, 2021, 04:22:26 AM »
Anyone?

No one did attempt to have Auto Z probe and Corner finder/work zero probe??

4
Mach4 General Discussion / Re: Probe 2 setup, Pokeys57cnc
« on: August 17, 2021, 04:59:01 PM »
Did you resolve your issue?? I'm on the same boat, I do have auto Z probe and I do want to add extra corner finder probe, I can see the LED working fine in MACH4 but it's not doing any probing. So signal is reaching MACH4 but nothing is happening.

5
PoKeys / Pokeys57CNC/Mach4 and 2 Probes
« on: August 17, 2021, 11:28:56 AM »
Hi Everyone

First post on the forum.
I'm on final stage of my build (3 axies CNC router)
I have successfully  installed Auto Z high for tracking tool high on the manual tool change.
Now I would like to install corner finder.
I have set up in Mach4 pin 16 as Probe 1 (g31.1) and on the diagnostic screen looks like is working fine, when I short wires I do have green LED.
But when I try preform edge finding Mach4 or Pokeys ignores the signal.
This is happening when I'm using MDI and build in Touch function in Mach4.

The confusing part is when the G31.1 is happening it will ignore probing signal, but it will react to G31!?

Thanks for all the suggestions, maybe there is a setting I'm missing seaware.


O and one last thing I did try to open ticket at PoLabs Support portal, but never received email to activate account. I have try 3 different email addresses with no luck did anyone experienced similar behaviour 
 

Pages: 1