Messages

1

General Mach Discussion / Re: Need help

« on: August 09, 2021, 06:58:14 PM »

 Got it ll figured out... It was the nut behind the keyboard... Forgot to toggle the reverse in the homing settings.

2

General Mach Discussion / Re: Need help

« on: August 09, 2021, 06:34:44 PM »

 Thanks. That did the trick.  Now my z axis is running in reverse of what it should be doing. Still running tests before I attempt my first cut. Any advice would be helpful. Thanks

3

General Mach Discussion / Need help

« on: August 08, 2021, 08:34:49 PM »

 I'm a total newbie to cnc and need some help or at  least a point in the right direction. I have a Zenbot 4848 with a Gecko 540 controller. My problem is that my Y axis and A axis slave are fighting each other trying to twist my gantry. If I unplug the A axis it operates fine. The A axis is operating in reverse. Did I miss something in the initial setup ?