Messages

1

General Mach Discussion / Ethernet dll for Bitsensor card

« on: October 10, 2022, 01:34:17 PM »

Hi does anyone have a working dll for a BitsensorBSMCI14E?
I have looked everywhere and can't seem to find them.

2

General Mach Discussion / Re: Displaying variables in a DRO

« on: May 28, 2022, 01:59:51 PM »

Thanks for that it's working now

3

General Mach Discussion / Re: Displaying variables in a DRO

« on: May 25, 2022, 02:15:47 PM »

Thanks for that, but how do I find the number of the OEMDRO?

4

General Mach Discussion / Displaying variables in a DRO

« on: May 23, 2022, 02:03:55 PM »

Please can someone tell me how to display a variable such as #500 in a DRO?
I can see how to use a system variable such as X position but not how to user variable.

5

General Mach Discussion / Re: Problem reading G31 sytem varibles

« on: August 06, 2021, 01:29:53 PM »

Thanks for all the help folks.
I think that I am getting somewhere now

6

General Mach Discussion / Re: Problem reading G31 sytem varibles

« on: August 05, 2021, 12:23:51 PM »

can val be a vb script variable?

7

General Mach Discussion / Re: Problem reading G31 sytem varibles

« on: August 04, 2021, 02:54:16 PM »

Can anyone tell me how to transfer a value from a vb script variable to a #variable

8

General Mach Discussion / Re: Problem reading G31 sytem varibles

« on: August 01, 2021, 05:33:56 PM »

I am coming to the conclusion that I need to buy another motion controller.
But I want to get it right this time.
I am running 4 axis but may need a 5th in the future.
the probe must work.
and I need at least 4 outputs plus  motor controls.
I would like to buy it in the UK.
and hopefully not hundreds of pounds.
Any recommendations?

9

General Mach Discussion / Re: Problem reading G31 sytem varibles

« on: August 01, 2021, 08:51:11 AM »

if Tweakie is still seeing this
I now have enough vbscript to display variables in a message box.
But I do not understand the results.
the #2002 #5023 and oemdro(802) all read zero
if I assign a value to #5023 either before or after the g31 code then I get the value that I have assigned.
I don't know what else to try

10

General Mach Discussion / Re: Problem reading G31 sytem varibles

« on: July 30, 2021, 01:03:01 PM »

I have now tried #50=[[2002]+2] still moving to 2 (so 0+2)
The plus 2 was because at one point I had it working and the value I got back was 2 higher than the z position I assumed some kind of probe compensation that I could not find.
the time it worked was after a new install but I have tried that again since and no joy.