Messages

1

General Mach Discussion / Re: slow jogging speed

« on: January 04, 2023, 06:44:01 AM »

That did the trick,thank you john.

2

General Mach Discussion / slow jogging speed

« on: January 03, 2023, 01:14:37 PM »

Hi all
I have a strange problem in mach3,my jogging speed is set a 75 and with the arrows its jogs just fine.
But when i add a code in the bar for example x0 z1 and enter its jogs horrebly slow with a lot off noise.

3

General Mach Discussion / mach3 xhc WHB04B mini lathe

« on: July 30, 2022, 03:51:47 AM »

hi i have the XHC WHB04B pendant and i like it very much,but there is one thing that i cant find out.
The z axe dro output are the same on pc and pendant,but my x axe shows different numbers,e.g- x axe on pc 100 mm  and the pendant shows 50 mm or is that normal.

4

General Mach Discussion / fusion 360 to mach3 mini lathe.

« on: July 18, 2022, 01:57:54 PM »

as i am still learning i use the turn wizzard.

I fill the data in the turn wizzard and post it to mach3,then i go in the manual screen and set the beginning point for my workpiece with part zero. zero z.
Its worked perfectly no problems
But when i post a drawing with fusion360 to mach3 and setting my zero z in manual mode the program begins not even close to my workkpeace,infact my x axe goes al the way backwords + is that

5

Mach4 General Discussion / part zero

« on: July 14, 2022, 04:22:06 AM »

In mach 3 you had a button part zero to set your workpiece 0 point,how do i set the workpiece 0 point in mach 4.

6

Mach4 General Discussion / Re: MACH4 Manual Screen

« on: July 13, 2022, 01:26:40 PM »

But how do install this screenset or screen,

7

Mach4 General Discussion / Re: MACH4 Manual Screen

« on: July 13, 2022, 01:06:44 PM »

And how do you install this screen?

8

Mach4 General Discussion / Re: reverse axe direction

« on: July 12, 2022, 06:19:05 AM »

Solved,my direction pin numbers were wrong, sorry for the trouble greekart thanks anyway.

9

Mach4 General Discussion / Re: reverse axe direction

« on: July 12, 2022, 05:01:03 AM »

In mach3 all was working fine,i use  uc100 motion controller.

10

Mach4 General Discussion / Re: reverse axe direction

« on: July 12, 2022, 04:14:29 AM »

Just try this and no change.