Messages

1

General Mach Discussion / Re: OEM Code 352, 353, 354 and 355

« on: October 10, 2007, 12:02:26 PM »

I am building a cnc foam cutter and need to move both axis with one key
The way it works now is that i need to hold two buttons on the keyboard in order to move two of the X axis for example.
I want to hold one button and move both X axis and hold down a different button and move them the other way
Same for the Y axis - want to move both Y axis by holding one button

I saw that the OEM codes 352 to 355 enable me to do so, but I can't get them to work

Thanks for your help

2

General Mach Discussion / Re: OEM Code 352, 353, 354 and 355

« on: October 04, 2007, 10:50:05 AM »

So what are the OEM codes 352 to 355 ?
Did anyone test them ?
I was able to get 352 to work, on the 2.X version but not on the 1.8X version
353, 354 and 355 didnt work on any version

3

General Mach Discussion / Re: OEM Code 352, 353, 354 and 355

« on: September 27, 2007, 11:31:35 AM »

I am emulating a parallel port pins -
I tried to slave, but since I am using a 4 axis machine, I need to be able to slave but a few sec later to use it as a single axis
Also I can't find a way to slave Z to a and at the same time A to Y

4

General Mach Discussion / Re: OEM Code 352, 353, 354 and 355

« on: September 25, 2007, 11:05:13 AM »

I am trying to run X and Z axis together and Y and A together.
Thanks

5

General Mach Discussion / Re: OEM Code 352, 353, 354 and 355

« on: September 25, 2007, 11:05:04 AM »

I am trying to run X and Z axis together and Y and A together.
Thanks

6

General Mach Discussion / OEM Code 352, 353, 354 and 355

« on: September 24, 2007, 01:09:37 AM »

Hello All
Trying to use OEM codes 352 to 355 with no sucsess - most of the OEM codes work other then these 4. Has anyone tried them ?
Thanks
Todd