Messages

1

General Mach Discussion / Re: Jogging Cont Step (PLEASE HELP)

« on: May 23, 2021, 06:32:04 AM »

maybe Config -> Port's&Pins -> Kernel Speed is set to a lower value?

Thanks for your reply, what speed should it be set at? Currently it's at 25000Hz, I haven't changed it since bringing the profile over from the last PC.

2

General Mach Discussion / Jogging Cont Step (PLEASE HELP)

« on: May 22, 2021, 06:25:35 PM »

Hi all,

I'm new to the forum and fairly new to Mach 3 and CNC.
I had Mach 3 on a computer controlling my CNC, it was working great, that computer got a little wet and stopped working so I set up Mach3 on another one. Now I have a problem with Jogging, it seems very slow, it used to fast jog upto around 1800 mm per minute, now its maxing out at 60 even at 100%. the motor tuning velocity and acceleration are the same before. Where can this jog speed be changed be set?