Hello Guest it is March 28, 2024, 05:32:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - IGoodwin

Pages: 1
1
General Mach Discussion / Re: Mach3
« on: May 07, 2021, 02:21:26 AM »
So you don’t enter any settings for the port number if it’s usb?  The driver takes care of the address?  Cheers Iain

2
General Mach Discussion / Mach3
« on: May 06, 2021, 09:03:03 AM »
Mach 3

Hi there...I've been looking for the correct port address to use for my USB controller....all the blogs I read mention the printer port address but I cannot find anything on USB settings.

Can any helps please?

Cheers

Iain

Pages: 1