Hello Guest it is August 17, 2022, 12:23:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PacoFlores

Pages: 1
1
General Mach Discussion / Re: Mach 3 and servo motors =S
« on: April 13, 2021, 10:26:29 AM »
Thank you, I really appreciate your answer. I will check the information above and choose one of them. Do you have some commentos or used one of them?? or another one??

2
General Mach Discussion / Re: Mach 3 and servo motors =S
« on: April 12, 2021, 04:23:05 PM »
so, I can use any type of controller board as long as mach 3 support it, isn't it?
Thank you

3
General Mach Discussion / Mach 3 and servo motors =S
« on: April 12, 2021, 09:33:36 AM »
Hello all

I am new with this topic. I am going to build a small CNC using servomotors (X-Y axis with 0.75kW motors ans Z a 1.3kW motor). When I was at University I used mach3 for a project but with steppers, I want to know if I can use mach 3 for the servomotors, also if you know some controller board to use with servo because in my search only appearce boards for steppers.

Hope you can help me.

Regards

Pages: 1