4
« on: September 21, 2007, 07:09:42 PM »
Hello Folks
My name is Alonzo. I am new to cnc. and forums, and ask for your patience while I learn my way around. I am 61 years old, and
have spent the last 40 years as a brick mason. I have allways had an intrest in woodworking,but my trade and it's physical demands left
little time or energy for it. I had a bad hip for years,and bought some woodworking tools(table saw,band saw,router,drill press etc.)
knowing that my bricklaying time was getting short. After a hip replacement I now have the time. Now for the reason that brings me
here. I would like to learn cnc to use in my hobby woodworking shop. I would like to learn to run MACH3 ( installed)in simulator mode.
Any help pointing me in the right direction for setting up,configuring,and running will be greatly appreciated.
Thanks Alonzo