Hello Guest it is March 28, 2024, 11:00:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kaminco

Pages: 1
1
General Mach Discussion / Violentlt fast "to home movement".
« on: April 03, 2021, 10:24:38 AM »
I just purchased the lisence for M3.

Now my gantry moves super fast to the home position when I push go to zero button.

My table is a dual drive home built unit using a a G540 controller.

In addition, I was able to make the table cut the road runner, but the part was super small.

It seems my problem started after the liscencxe install.

Any suggestions?  Please respond like I'm 10 (actually 53).  I'm very new to this.  I'm a nuckle drtagging fabricator with enough computer knowledge to be dagerous.

Here is a vid of what I am so far capable of.
https://youtu.be/6W6_TBVMNW0

Thank you

Kirk

Pages: 1