Messages

1

General Mach Discussion / safety guard

« on: November 10, 2023, 10:50:07 AM »

i activate pin n^1 and condition in general config.
its all ok but when my guard is open gcode is in pause but spindle continue rotation. why?

2

Galil / Re: Question about Galil and Mach3 interaction

« on: February 22, 2021, 08:57:43 AM »

yes but the plugin is paid so how can you not answer the questions of those who buy?
then this plugin works fine?
I see there are many problems around. do you have to buy with your eyes closed? for example the acceleration speeds are managed by mach or always galil?