Messages

1

Mach4 General Discussion / G68 ain´t not working any longer...

« on: August 19, 2021, 02:48:41 PM »

Using Mach 4, hobby licence, version 4.2.0.4300.


G68 did work fine. Touch probe tested the degree, status line prompted it. G68 was in bottom statusline AND moving along in x I could see in DRA y slightly correcting the travel.

NOW this function is gone . G68 is promted after Probe, but no correction takes place. Even if I put in higher angles by G68 X0 Y0 R25 in MDI, there is no correction at all. G69 and G68 just switch in status line but no effect....

How to get G68 working again?

2

Mach4 General Discussion / Re: Lua: Error while running chunk

« on: February 13, 2021, 04:11:08 AM »

OK, could fix it.

Engraving error was, cause font.lua was not found. Copied it into on of the search folders mentioned in history and it´s working again.
Error with pmc was that name had blanks in it.

3

Mach4 General Discussion / Lua: Error while running chunk

« on: February 12, 2021, 05:15:01 PM »

Hi, Mach4 crashed while running Font engraving wizard. Now I get "Lua: Error while running chunk" whenever starting that wizard - and too whenever attaching an PMC gennerated Lua script to my screen.

Any idea how to fix it?