1
General Mach Discussion / M40 / M41 touch probe not working.
« on: January 29, 2021, 06:59:03 AM »
Hello everyone, this is my first post here.
I tested the touch probe by writing the data to a text file, but Mach3 stops working after the M40 entry and dont write a text file.
The UNCNC manual states that it is supported. Why not also with mach3?
Thanks.
I tested the touch probe by writing the data to a text file, but Mach3 stops working after the M40 entry and dont write a text file.
The UNCNC manual states that it is supported. Why not also with mach3?
Thanks.