Hello Guest it is March 28, 2024, 09:55:18 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bportelli

Pages: 1
1
General Mach Discussion / Re: Mach3 with STB5100
« on: January 17, 2021, 11:26:47 PM »
that controller does not work in slave configuration
to sync dual y axis stepper motors you need to split/share signal wires that go from the breakout board to each individual stepper driver unit.

as ive been running mine like that for over a year now on small machine, and just looking now after a machine upgrade to find a new breakout board to swap from the stb5100 that supports slave so i can get auto gantry operation working as intended

Pages: 1