1
Third party software and hardware support forums. / [Help] Usb board don't trigger e-stop or home/end switches
« on: December 09, 2021, 09:58:15 AM »
Hi everyone
Im still trying to finish my build but after some good progress (motor working good, all ports and pins configured) i get stuck trying that this Breakout board recognise when i press the end stops, home or emergency stops...
Everyting is wired like they said, i move the motor and when i press the endstops the motor continue like nothings happen
This is the board:
It came with a cd with some plugin that is that i already put, and a manual that sais the numbers of ports and pins
I don't have anything more than that. So i suspect that im not geting something.
This is the wiring diagram
Any idea from where to start checking?
Im still trying to finish my build but after some good progress (motor working good, all ports and pins configured) i get stuck trying that this Breakout board recognise when i press the end stops, home or emergency stops...
Everyting is wired like they said, i move the motor and when i press the endstops the motor continue like nothings happen
This is the board:
It came with a cd with some plugin that is that i already put, and a manual that sais the numbers of ports and pins
I don't have anything more than that. So i suspect that im not geting something.
This is the wiring diagram
Any idea from where to start checking?