Hello Guest it is March 29, 2024, 10:56:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nitroz

Pages: 1
2
General Mach Discussion / Re: Mach3 with STB5100
« on: January 06, 2021, 02:27:55 AM »
you wouldnt be happening to be running a TB6560 stepper motor driver ?? If so it may be because you havent setup microstepping. The controller itself doesnt have pins its the stepper motor board. The pins setup the microstepping in my case 1/8th was the trick.

Pages: 1