Hello Guest it is March 28, 2024, 05:32:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - exaustgas

Pages: 1
1
General Mach Discussion / Re: Spindle Dwell Time Mach 3
« on: December 15, 2020, 02:32:08 PM »
Thank you, I appreciate the response. Got it working now.

2
General Mach Discussion / Spindle Dwell Time Mach 3
« on: December 14, 2020, 03:24:23 PM »
I seem to get a minimum spindle dwell time with all M3 and M5 commands of at least 1 maybe 2 seconds. I have gone into port and pins, spindle tuning and set the dwell times to 0, but it still delays.

I just added a laser to my router, and use the m3 and m5 commands to turn it on and off. The laser turns on and off great, but the dwell means I'm sitting there burning the workpiece. Any suggestions?

Pages: 1