Hello Guest it is March 28, 2024, 10:26:26 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 10M

Pages: 1
1
Newfangled Mill Wizard / Re: So a PC failed
« on: December 13, 2020, 02:12:53 PM »
So, I too have a question about the computer ID. If it is the same computer and I just re-image the drive (which I am likely to do once in a while) will it produce the same computer ID? I was just about to buy the Mill Wizard license but I am also getting ready to re-image the drive over the holidays and I will wait if this is the case. I have just bought the license for the included Wizards Suite and I will install the license file to the machine tomorrow.
I have just found and worked out how to use the Wizards in Mach3 and I have found them to be incredibly useful. I am just starting out learning BobCAD Cam so this lets me actually use the machine without wrestling with a CAD package that I do not yet understand.
Can someone let me know please, thanks.

Pages: 1