Hello Guest it is April 24, 2024, 12:59:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - smtpl

Pages: 1
Modbus / Re: Can A Modbus control a.........
« on: January 30, 2011, 05:02:23 AM »
How can I use event driven serial control in Mach3?

Mach Screens / Button press output
« on: October 18, 2007, 07:06:33 AM »
I want to create a button which activates output pin while I press the Button & deactivates output when I release. Also I want a button which runs VB code on press event as well as on release event. Is anybody there tried out this? Or help me?

General Mach Discussion / Spindle problem
« on: September 19, 2007, 02:24:03 AM »
When I start spindle through relay control it run for some time and then it stops if I do nothing on mach3 screen. When I start doing something on screen e.g. jogging then spindle starts again. Plaease help me to sole this problem.

General Mach Discussion / Re: Mach3 Jog overide
« on: September 17, 2007, 05:33:24 AM »
I don't want to get full jog speed. My problem is that I have set slow jog rate & if keyboard's shift key pressed down and locking it down intermittently then unnecessarily jog rate goes to full speed that I don't want. So I want to remove this shift key assigned to jog speed override. Can I do this? How?

General Mach Discussion / Mach3 Jog overide
« on: September 16, 2007, 02:45:24 AM »
Any body tell me how can I remove jog override effect of shift key press.

Pages: 1