Hello Guest it is March 28, 2024, 11:15:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ken Make Tech

Pages: 1
1
*****VIDEOS***** / Sci fi / Space X theme UI and scripts Video.
« on: January 21, 2021, 09:39:42 AM »
Here I've modified the UI to a sci fi / Space X theme.
M6 tool change macro checks tool for breakage.
Allot of IO coding for notifications and control.
Special thanks to Daz for his videos and posts.
https://youtu.be/iG6uo3-hMWs

2
Mach4 Videos / Sci fi / Space X theme UI and scripts Video.
« on: January 21, 2021, 09:17:57 AM »
Here I've modified the UI to a sci fi / Space X theme.
M6 tool change macro checks tool for breakage.
Allot of IO coding for notifications and control.
Special thanks to Daz for his videos and posts.
https://youtu.be/iG6uo3-hMWs

3
Mach4 General Discussion / Re: ESS PWM spindle open loop
« on: December 12, 2020, 04:15:25 AM »
SOLVED!
I'm using these BOB from steppers online. It has a built in low pass filter that was the cause of this slow up ramp. I have now used a normal 5v output pin and added my own low pass filter. I've setup the VFD analogue input to 5v and its working perfectly.

The new version of the plug in triggered a compatibility warning and based on the above info it obviously didn't fix my issue, so I've rolled it back.

4
Mach4 General Discussion / Re: ESS PWM spindle open loop
« on: December 11, 2020, 11:39:42 AM »
Over on the Warp9 forum, Andrew tells me I should try a newer version of the plugin -> 259.
So I will give that a go.

5
Mach4 General Discussion / ESS PWM spindle open loop
« on: December 11, 2020, 10:18:59 AM »
Hi all. On mach4 with the ESS, I am driving the VFD with PWM signal but it ramps up too slowly. Changing the settings has no effect on the PID.
Any help much appreciated.
Cheers
-Ken
https://www.youtube.com/watch?v=A0Pth6P23oM

Pages: 1