Messages

1

General Mach Discussion / MPG controler and mach3

« on: March 22, 2021, 04:29:55 PM »

Hey I am considering buying an MPG controller Machifit Wireless Electronic CNC Handwheel. I am using win XP with uc100 motion controller and Mach3. if anyone has experience with this, will it work? I am a bit suspicious because an xbox 360 contrler does not work.

2

General Mach Discussion / Re: zero setting changes after running program

« on: March 01, 2021, 11:12:10 AM »

I have installed v3.043_2018 but here I get the same problem but a little less.
Sometimes the coordinates remain correct.

3

General Mach Discussion / Re: zero setting changes after running program

« on: February 27, 2021, 10:47:11 AM »

I am running v.R3.043.066

4

General Mach Discussion / Re: zero setting changes after running program

« on: February 27, 2021, 10:42:27 AM »

Is the ESS plugin for using an ethernet connection?
My controller for the milling machine only works with parallel port. I have a 6040Z-S80 cnc milling machine.

5

General Mach Discussion / Re: zero setting changes after running program

« on: February 27, 2021, 03:09:16 AM »

Hey
Thank you already for the answer. Yes the Persistent Offsets and Persistent DROs are selected. Things have been getting worse lately. I could pause the program and then manually go to zero, this no longer works because the machine coordinates are now also changing. It makes me desperate

6

General Mach Discussion / Re: zero setting changes after running program

« on: February 07, 2021, 04:02:48 AM »

Thanks for the reply.
I mean pause and stop on the way back to zero after ending the program

7

General Mach Discussion / Re: zero setting changes after running program

« on: February 07, 2021, 03:34:38 AM »

The machine is physically at zero except for the Z axis. When I pause and stop the program the coordinates don't change.

8

General Mach Discussion / Re: E stop

« on: February 06, 2021, 07:08:06 AM »

Thanks for the reply i wil change the kable from the E stop

9

General Mach Discussion / E stop

« on: February 06, 2021, 05:58:10 AM »

During the program I often get an e stop emergency. Sometimes none and sometimes several times in the same program. What could be the cause of this

10

General Mach Discussion / zero setting changes after running program

« on: February 06, 2021, 05:54:18 AM »

My cnc mill works under win xp. I am using mach3 the latest version. I want to run a program on my mill several times in succession. The problem is that I have to set the zero setting every time again.
When the program is done the spindle goes to the zero position, but then it changes the coordinates of X, Y and Z. What is the problem here.