Hello Guest it is March 28, 2024, 05:06:36 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mitch

Pages: 1
1
General Mach Discussion / Support videos without Flashplayer
« on: December 14, 2020, 06:54:19 AM »
Hi,
I am new to Mach3 (upgrading an old cnc gantry router).  I am trying to watch the Artsoft videos but the site requires Flash Player which is now obsolete.  How can I watch them please?  I have found the first 3 basic Art videos on Yoytube, but Art refers to more advanced videos to follow but I cannot find them.  I can only get as far as the faults video for those upgrading from Mach2 to3 - very useful for me even though I did not have Mach 2.  Wish I could find the rest in the series - if there are any?
Grateful for any advice
Mitch

Pages: 1