1
Mach4 General Discussion / Re: Enhanced stupidity between 2 machines
« on: March 07, 2021, 02:47:06 PM »
Nick, Huge thanks for the input.
I checked that between both profiles and they were set the same (incremental)
Gave up and set up a new profile (from scratch, imported nothing), which was not fast . .
Looked ok, imported G code fine, toolpath was as it should be, I was a happy little bunny . . . . but.
Everything was teeny tiny . . .
Scratched head, looked at motor setting in the ESS plug in and the Mach controller, all same same . .
for some reason looked at the general tab and it had defaulted to inches . . . . . gaaaar.
Bloody colonials . . set it back to Metric and all is well in my (now) slightly whisky infused world.
I have not the foggiest what was wrong.
However, it all works now.
I checked that between both profiles and they were set the same (incremental)
Gave up and set up a new profile (from scratch, imported nothing), which was not fast . .
Looked ok, imported G code fine, toolpath was as it should be, I was a happy little bunny . . . . but.
Everything was teeny tiny . . .
Scratched head, looked at motor setting in the ESS plug in and the Mach controller, all same same . .
for some reason looked at the general tab and it had defaulted to inches . . . . . gaaaar.
Bloody colonials . . set it back to Metric and all is well in my (now) slightly whisky infused world.
I have not the foggiest what was wrong.
However, it all works now.